Go to video page to watch this video

Geovital Academy
Home & Office assessment for Geopathic Stress and Electronic Pollution.

30 Year experience in making homes healthier.

Call us today.

Assessors wanted!
We always welcome those who get certified by our academy to work with us and expand our nation wide network of Geovital assessors.
Contact us about a 2.5 day course.
We have discounts for those travelling from far away.

MEDISEND shields you from electro pollution effects. read below.


TriField Meter, a guide on how to measure:

There are magnetic fields etc produced within the building and those put upon you from outside sources like the electrical net through your street, suburb and city, mobile phone towers, broadcast stations etc. Firstly determine how much exposure you receive from outside, by turning everything off in your building, preferably by the master switch in the meter box. Take your measurement through out the building (write them down) so you can then truly measure the total exposure when the power is switched back on. The difference between the two is obviously the effect of factors within your building.

Measure through out the building, paying special attention to places where people and pets spend a lot of time. Turn on typical appliances you would use in these areas, like the tv or stereo in the living room. Places to measure could be the sofa, your rocking chair, dining table, kitchen and certainly the beds.

What you could find. 'Hot Spots'

Combinations of fields around you can cause 'hot spot' where the combination of exposure is high. You would want to reduce hot spots by turning off, removing or moving appliances. If that is not beneficial, or you want to do more, you could avoid spending time in found hot spots. So if your favourite chair is right in a hot spot, move it somewhere where the exposure is less. If you run out of ideas of what to do, just want someone's input and certainly before you make costly changes like re-wiring or moving, you should contact a specialist in this field to come and assess your property professionally.

The TriField Meter 100XE - AU$195 plus postage

Manufactured in the USA by AlphaLab, Inc.

Cases for Trifield meter now availableThe original TriField ® Meter combines all the features needed for fast, accurate measurements of electromagnetic fields. It independently measures electric field and magnetic field, and is properly scaled to indicate the full magnitude of currents produced by each type of field inside a conductive body. As a result, it "sees" much more than any other electromagnetic pollution meter.

NOW WITH FREE GEOVITAL ACADEMY TRIFIELD METER USER GUIDE
Free Trifield Meter user guide by Geovital AcademyThe original instruction manual that come with the Trifield meter is a little small and more technical than anything else. Geovital Academy, who train people in making professional assessments of properties, have developed a small Trifield Meter user guide with hands on tips and ticks on how to use the Trifield meter, what to measure and look out for, what levels to be aware of etc etc. It is easy to operate the Trifield meter, but with this user guide you will also have confedence that you are using it correctly. When you purchase your Trifield meter from us it is included FREE OF CHARGE.

Depending on where the knob is set, the meter detects either frequency- weighted magnetic fields (two separate scales), or frequency-weighted electric fields in the ELF and VLF range. It has significant sensitivity at 100,000 Hz, well past the 17,000 Hz horizontal scan of video displays. The radio/microwave setting can detect up to three billion Hz (3 GHz), which lets you gauge radio- wave power, CB and cellular phone equipment, and many types of radars.

This meter is the only one which combines magnetic, electric, and radio/microwave detectors in one package, so that the entire nonionizing electromagnetic spectrum is covered. In addition, the magnetic setting and the electric setting measure true magnitude, a feature found elsewhere only in more expensive meters. If you hold the meter in the center of a room and tip it to various angles, the magnetic reading will stay approximately the same regardless of which way you tip or rotate it. The electric reading is similar, although the presence of your body alters the actual electric field, so readings will vary more. The radio/microwave setting reads the full power of radiowaves when the meter is pointed toward the source.

Surprisingly, the standard TriField Meter is one of the least expensive meters available. The few other meters below $300 read only low-frequency magnetic fields and only in one direction (not true magnitude). The magnetic section of the TriField meter has three field-detecting coils pointing in the X, Y, and Z directions. A circuit amplifies these signals and gives them the proper frequency-weighting (sensitivity increases linearly from 30 Hz to 500 Hz, but with some residual sensitivity up to 100 kHz). A unique network combines the three coil outputs nonlinearly to approximate a true magnitude. The meter is sensitive from 0.2 to 100 milligauss full scale at 60 Hz (or 0.1 to 50 milligauss full scale at 120 Hz, etc.) with a resolution of 0.2 milligauss in the sensitive range. Accuracy is +/-20% at mid-range. A version with flat frequency response (instead of linear sensitivity increase) is also available for the same price.

The TriField Meter comes with a 9-volt transistor battery included. This type of battery lasts about 10 hours (total measurement time). When the BATTERY TEST reads low, the battery can be replaced with any rectangular 9 volt transistor or alkaline (which lasts about 50 hours) type. This meter is manufactured in the USA. TriField is a registered trademark of W.B. Lee.

Features:

Applications:

SPECIFICATIONS: Trifield® Meter
AC Magnetic Fields: (3-axis; shows true magnitude)
Frequency Range: 40 Hz – 100 KHz (see frequency weighting)
Accuracy @ 60 Hz (50 Hz): +/- 20% of reading
Range/Resolution (@ 60 Hz or 50 Hz): 100 milligauss / 0.2 milligauss
Standard Version Frequency Weighting:  
*Sensitivity is proportional to frequency from 40 Hz to 500 Hz; flat from 500 Hz to 2000 Hz
*Sensitivity is inversely proportional to frequency from 2K Hz to 100K Hz
Flat Frequency Version: +/- 20% from 50 Hz to 500 Hz; inverse frequency above 500 Hz
AC Electric Fields: (3-axis; however, note that E-field is affected by the body position)
Frequency Range: 40 Hz – 100 K Hz (see frequency weighting)
Accuracy @ 60 Hz (50 Hz): +/- 30% of reading
Range/Resolution: 1000 V/m / 5 V/m (Original Version: 100 KV/m / 0.5 KV/m)
Frequency Weighting: Same as magnetic (above).
Frequency Range: 50 MHz – 3000 MHz (3 GHz)
Range/Resolution: 1 mW/cm2 / 0.01 mW/cm2
Accuracy: ½ x to 2 x of reading
Meter Size: 5.0 x 2.6 x 2.4 in (129 x 67 x 62 mm)
Weight: 8 oz
Battery: 9 volt alkaline (~ 40 hour life) / "Low Battery" indicator

 

Using The Trifield Meter

A knob on the front has six positions: OFF, BATTERY TEST, two MAGNETIC field sensitivities (0.5-100 milligauss at 60 Hz, and 0.2-3 milligauss at 60 Hz, the second sensitivity to measure weak fields more accurately), ELECTRIC field and RADIO/MICROWAVE power density. The meter face is analog (needle type). A needle reading of one-third of full scale corresponds to either 3 milligauss (or 0.6 milligauss) @ 60 Hz, 3 kilovolts/meter @ 60 Hz, or 0.04 mW/cm2 respectively in the magnetic, electric, and radio/microwave field settings. Average magnetic field strength in North American homes and offices is 1-3 milligauss, so the meter is labeled "HIGH" above these levels.

Magnetic Field Detection

In most homes or offices, some areas are "hot" spots with readings in the HIGH range. Most often, this is caused by magnetic fields, which come largely from unpaired internal wiring. (Contrary to popular belief, power transmission lines and transformers do not generally contribute as much magnetic field as does internal wiring.) Other magnetic sources include video displays, motorized clocks and other equipment, electric blankets and heaters, fluorescent lights and light dimmers, and the transformers that are inside consumer devices. Much of the total field strength is from frequencies that are harmonics or multiples of 60 Hz (120 Hz, 180 Hz, etc.) and 17,000 Hz of video displays. Cars (especially near the front floorboard of electronic ignition cars) and motorcycles have fairly strong fields that are at frequencies higher than 60 Hz. Magnetic field is difficult to shield, but sheet steel is somewhat effective.

Electric Field Detection

A few areas in most homes read HIGH in the electric field setting. These include areas near improperly grounded equipment, the front of video screens, and fluorescent lights. Most of these fields can be easily shielded using a grounded metal screen or foil; VDT screens of this type are readily available. You can greatly reduce the strength of an electric field just by placing your hand in front of the source. This effect can be seen using a TriField meter.

Microwave Detection

Occasionally, certain areas read HIGH in the radio/microwave setting. These include door seals around microwave ovens, and cellular phones (but not regular radio phones, which are very low-power). Radio/microwaves can be shielded in the same way as electric fields, although the lower frequency radio waves are not shielded by your hand as easily as microwaves are. (Metal screens will shield both.) In the United States, radars and FM transmitters can legally expose residents to moderately high power levels (as high as 10 mW/cm2 briefly or .57 mW/cm2 near cellular towers), but such exposure is not common.

Reducing Field Exposure

Some equipment is sensitive to magnetic fields (ie, a high resolution color monitor may not function properly above 30 milligauss). By seeing "hot" spots in your home and office, you can move equipment or furniture to reduce exposure. If a room has a "hot" spot, fields are generally much weaker elsewhere in that same room.

Purchase your TriField Meter now and take control.
Improve your life, the environment of your loved ones, or your clients well being.

Trifield Meter with

Trifield Meter is just $195 incl. GST plus $15 postage.

add the optional case to your order for just $49 with no added postage.
(Case on its own: $49 plus $15 postage)

Trifield meter caseRing us to arrange payment
and we will send it out to you as soon as possible.
0407 680 812 or 03 9020 1330

Payment by Credit Card possible

 

 

Worn under uniforms and work shirts all over the world...
MEDISEND by AMS

Shield yourself from effects of electronic pollution from equipment at work or your mobile phone.

It is of course better to not be exposed to electronic pollution at all but sometimes work or dependability on a mobile phone make people think its unavoidable at times. Advanced Medical Systems (AMS) GmbH of Germany is the continuation of the life's work of Dr Ludwig who is considered the father of pulsating magnetic field therapy. He designed a small device (about the size of a matchbox) called the MEDISEND. The MediSend reproduces the same magnetic fields as you would experience in free nature, including geomagnetic waves as from the 64 trace elements in the earth's crust. Combined with the ability to set 9 different 'frequencies' to achieve different effects and benefits, this device has many loyal users all over the world.

How does the Medisend help you?
The MediSend has, amongst 8 other frequencies, a special frequency that has shown to alleviate/shield its user from effects of electronic pollution. For example people who work all day with computers, x-ray equipment, metal detectors etc often find themselves fatigued greatly, sometimes depressed, headaches, overall weakness, a feeling you can not shake simple illnesses like a cold as quickly as you used to and a general increased susceptibility to illness due to a weakened immune system. The Medisend can be worn all day. Placed in trouser pockets with mobile phones to fight their weakening effects, or worn on the chest easily hidden under business attire. They have proven to be popular with customs or security officials, although few will share this their colleagues.

(To read about other abilities if the Medisend, please check out the small devices sections)

The Medisend is sold exclusively by OxyMed in Australia and New Zealand with a 60 day satisfaction guarantee.
Read satisfaction guarantee

This allows you to try it out, experiment with all the settings and see if it meets your satisfaction criteria. Most importantly, you experience how much it will improve you life. Click image for details.

It used a small AAA battery which last a long time, is user replaceable and the device is easy to operate.

The MediSend can be found with other hand held devices here. Keep in mind that the MediSend is the only one of the small devices which can be set to not turn off until you deactivate it. Perfect in regards to shielding for the whole day.

We know you will love it. Get one today.
AU$489 including gst plus $20 postage within Australia.

Payment by Credit Card possible